Made A Massive Boo Boo

[ScottE]

Hello People,

I have a Technics 1210 II.

I do not know why I did this and no I wasn't pissed.

I wanted to change the speed of my turntables and instead of adjusting
the speed setting I changed the voltage from 240v to 120v and I forgot
to change it back before turning it on.

Well you guessed right the thing blew !!!! :$ :$ :$ :$

I have changed the fuse in the plug but this has not worked.

Can anyone tell me what has gone wrong and whether it is an expensive mistake ???

Thanks

Scott

 

[woody]

sounds nasty mate id guess that there's plenty of internal fusing and stuff to protect the components.. so you've prob blown them

try your local technics dealer, but i dont hold much hope as they couldnt get me a replacement circuit board for mine :S you may have to either leave them with them or pick up a 2nd hand deck for spares and make one good one from the two

good luck fella

 

[ScottE]

Cheers

Woody,

Cheers for the reply and I don't hold out much hope.

Dropping it off with a electronics engineer tomorrow.

Cheers

Scott